TECHNICAL SPECIFICATIONS

TECHNICAL SPECIFICATIONS OF SYSTEM COMPONENTS:
In order for the system components to work in harmony; All components (heating cables, digital thermostats, sensors and mounting elements) must be sold by the same vendor. This situation should be documented with the approval of the manufacturer.

DEFINITION, PURPOSE AND SCOPE OF THE SYSTEM:
• System; It provides total or partial heating with floor heating, which is the most ideal type of heating in indoor environments (home, office, etc.).
• The main components of the system; heating cables, associated mounting elements and thermostats and sensors (sensor)
• Heat insulation must be...(Read more)

Definition, Purpose and Scope of the System

1. Electric bath heating system; It provides “floor heating”, which is the most ideal heating system for the bath.
2. System; Apart from heating cables and mounting parts, it consists of sensing components such as sensors and thermostats.
3. System; It will be designed and implemented to work fully automatically. For this purpose, heating cables, thermostats and sensors to be laid in the bath area are activated according to the change in weather conditions. The system will automatically deactivate after completing its task.
4. The heating power throughout the bath should be at...(Read more)

1.0) CODES AND STANDARDS

1.1) The Electric Heating System must be designed, manufactured, installed and tested in accordance with the latest version of the following codes and standards;

1. National Electrical Code (NEC/NFPA 70)
2. CENELEC Norms
3. National Fire Protection Association (NFPA)
4. National Electrical Manufacturers Association (NEMA)
5. American National Standards Institute (ANSI)
6. Institute of Electrical and Electronics Engineers (IEEE)
7. International Electrotechnical Commission (IEC)
8. All applicable local standards

1.2) The Electric Heating Cable manufacturer must have ISO 9001 certification.

2.0) ENVIRONMENTAL CONDITIONS

2.1 Minimum Ambient Temperature: -30°C

2.2 Maximum Ambient Temperature: 40°C

2.3 Average Temperature: 15 °C

1. The design and application of the heating cable or mattress system shall be made by taking into account human and material safety.

2. Snow drifting should be prevented on roofs with snow traps.

3. Snow accumulated there shall be melted by using a heating cable or mattress in front of the snow trap.

4. The heating cable or mattress to be used in roof gutters or roof overhangs shall be suitable for roof winter conditions, and this material shall be able to operate without problems under snow and ice.

5. The control panel containing snow/ice detectors...(Read more)

General Features

1. Electric heating mats/cables are used for two purposes in cold rooms.

a) Preventive heating below the frost level: In order to prevent damage to the structure due to freezing of the cold room floor concrete, concrete under the ground heat insulation layer and/or water in the soil ground;

i) The heating load for this application should be at the level of 10 W/m² -15W/m².

ii) There should be a spare circuit in cold rooms below -15o C degrees.

iii) A mat prepared for this purpose should be used or if...(Read more)